About Us Products Feedback Contact Us Site Map Home
Products> Push On Fittings For Instrumentation & Pneumatic Control Systems
 

1. Recommended Tubing
Polyurethane, Polyethylene, Soft PVC and super Flexible Nylon Tubings are most compatible for Push-On Fittings.

2. For Connecting
Cut the tubing to length with tube cutter and just push it into the fitting through nut and tighten the nut by hand.

3. For Disconnecting
Loose the nut and pull the tube out.

4. No Tools Needed for Tubing Installation
No Wrenches, haring tools, benders or other tools are required for installation.

5. Reduce Installation Time and Labour Cost
Minimum of 36% saving in installation time, compared to regular compression type fitting.


6. Excellent Holding Power
When assembled finger tight on Nylon, Polyurethane, Polyethene or PVC tubing will hold the burst pressure of the tubing itself.

7. Pipe Swivel Possible
By loosing nut slightly pipe can be swivel on its own by 3600 where other end of the fitting will point.

8. Working Pressure Range
0 - 15 bar

  • Fuel lines for petrol or diesel fuel in Automobile and Transport Industry.
  • Compressed air lines on pneumatic control systems.
  • Automotive gasoline lines.
  • Automotive hydraulic lines.
  • High pressure lubricating oil line in Engineering and Automotive Industry.
  • Lubes and air lines on textile machinery.
  • Agricultural spray equipment for insecticides and fertilizers.
  • Transporting lines for alimentary liquids such as milk and beer and biological liquids such as blood, serum etc.
  • In the Chemical industries for conveying hydrocarbons, esters, ketones etc.
  • Refrigeration Lines.
  • Ducts in air conditioning systems.
  • Centralised lubrication systems.


Office : A-20, Sarvonnati Society, Hansoti Road, Cama lane, Ghatkopar (W), Mumbai - 400086.
Tel. : +91 22 25149190, 25116469, Fax. : +91 22 25111173, Mobile : +91 9820023817 (Mr. Yogesh Shah)
Email : yogdeep@vsnl.com, yogdeep1978@yahoo.co.in, yogdeep_enterprise@hotmail.com